Be default, even after you had successfully installed SCOM 2012 into your environment, it will be in Evaluation version.
Searching around the net, you might have found the ways to inject the productID but unfortunately for me, it does not seemed to be smooth for me. After a few tries, the following should be the easiest way (at least to me
) to apply the product key.
- run the PowerShell via elevated permission
- follow the commands as attached above
Once successfully done, repeat the steps in all other SCOM servers you have in your environment. Once done, it is best to reboot your SCOM servers. After the server is reboot, launch the SCOM console again and check if license key had been successfully registered. If it is, then you will see the status similar to the below
No comments:
Post a Comment